C613-50631-01 Rev A Command Reference for IE340 Series 1893
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-SMV6 COMMANDS
SHOW
IPV6 PIM SPARSE-MODE MROUTE
show ipv6 pim sparse-mode mroute
Overview Use this command to display the IPv6 multicast routing table, or the IPv6 multicast
routing table based on the specified IPv6 address or addresses.
Two group IPv6 addresses cannot be entered simultaneously; two source IPv6
addresses cannot be entered simultaneously.
For information on filtering and saving command output, see the “Getting_Started
with AlliedWare Plus” Feature Overview and Configuration_Guide.
Syntax
show ipv6 pim sparse-mode mroute
show ipv6 pim sparse-mode mroute <group-IPv6-address>
show ipv6 pim sparse-mode mroute <source-IPv6-address>
show ipv6 pim sparse-mode mroute <group-IPv6-address>
<source-IPv6-address>
show ipv6 pim sparse-mode mroute <source-IPv6-address>
<group-IPv6-address>
show ipv6 pim sparse-mode mroute brief
Mode User Exec and Privileged Exec
Usage notes Note that when a feature license is enabled, the output for the show ipv6 pim
sparse-mode mroute command will only show 100 interfaces because of the
terminal display width limit. Use the show ipv6 pim sparse-mode mroute detail
command to display detailed entries of the IPv6 multicast routing table.
Examples
awplus# show ipv6 pim sparse-mode mroute
awplus# show ipv6 pim sparse-mode mroute 2001:db8::
awplus# show ipv6 pim sparse-mode mroute 2001:db8:: 2002:db8::
awplus# show ipv6 pim sparse-mode mroute brief
Parameter Description
<group-IPv6-
address>
Group IPv6 address, entered in the form X:X::X:X. Based on
the group and source IPv6 address, the output is the selected
route if present in the multicast route tree.
<source-IPv6-
address>
Source IPv6 address, entered in the form X:X::X:X. Based on
the source and group IPv6 address, the output is the selected
route if present in the multicast route tree.
brief Brief display.
To Next Page
Loading...
Need help?
General
