Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 2445
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
RADIUS COMMANDS
RADIUS
-SERVER TIMEOUT
radius-server timeout
Overview Use this command to specify the RADIUS global timeout value. This is how long the
device waits for a reply to a RADIUS request before retransmitting the request, or
considering the server to be dead. If no timeout is specified for the particular
RADIUS server by the radius-server host command, it uses this global timeout
value.
Note that this command configures the timeout parameter for RADIUS servers
globally.
The no variant of this command resets the transmit timeout to the default (5
seconds).
Syntax
radius-server timeout <seconds>
no radius-server timeout
Default The default RADIUS transmit timeout on the system is 5 seconds.
Mode Global Configuration
Examples To globally set the device to wait 20 seconds before retransmitting a RADIUS
request to unresponsive RADIUS servers, use the following commands:
awplus# configure terminal
awplus(config)# radius-server timeout 20
To set the RADIUS timeout parameter to 1 second, use the following commands:
awplus# configure terminal
awplus(config)# radius-server timeout 1
To set the RADIUS timeout parameter to the default (5 seconds), use the following
commands:
awplus# configure terminal
awplus(config)# no radius-server timeout
To configure the RADIUS server timeout period globally with 3 seconds, use the
following commands:
awplus# configure terminal
awplus(config)# radius-server timeout 3
Parameter Description
<seconds> RADIUS server timeout in seconds in the range 1 to 1000.
The global time in seconds to wait for a RADIUS server to reply to
a request before retransmitting the request, or considering the
server to be dead (depending on the radius-server retransmit
command).

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English