Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 178
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
FILE AND CONFIGURATION MANAGEMENT COMMANDS
SHOW
BOOT
show boot
Overview This command displays the current boot configuration.
We recommend that the currently running release is set as the current boot image.
Syntax
show boot
Mode Privileged Exec
Example To show the current boot configuration, use the command:
awplus# show boot
Output Figure 3-8: Example output from show boot
awplus#show boot
Boot configuration
----------------------------------------------------------------
Current software : IE340-5.5.3-0.1.rel
Current boot image : flash:/IE340-5.5.3-0.1.rel
Backup boot image : flash:/IE340-5.5.2-2.1.rel
Default boot config: flash:/default.cfg
Current boot config: flash:/my.cfg (file exists)
Backup boot config: flash:/backup.cfg (file not found)
Autoboot status : disabled
Table 3-1: Parameters in the output from show boot
Parameter Description
Current software The current software release that the device is using.
Current boot image The boot image currently configured for use during the
next boot cycle.
Backup boot image The boot image to use during the next boot cycle if the
device cannot load the main image.
Default boot
config
The default startup configuration file. The device loads
this configuration script if no file is set as the startup-
config file.
Current boot
config
The configuration file currently configured as the
startup-config file. The device loads this configuration file
during the next boot cycle if this file exists.
Backup boot config The configuration file to use during the next boot cycle if
the main configuration file cannot be loaded.
Autoboot status The status of the Autoboot feature; either enabled or
disabled.

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English