C613-50631-01 Rev A Command Reference for IE340 Series 484
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
LOGGING COMMANDS
LOG
TRUSTPOINT
log trustpoint
Overview This command adds one or more trustpoints to be used with the syslog
application. Multiple trustpoints may be specified, or the command may be
executed multiple times, to add multiple trustpoints to the application.
The no version of this command removes one or more trustpoints from the list of
trustpoints associated with the application.
Syntax
log trustpoint [<trustpoint-list>]
no log trustpoint [<trustpoint-list>]
Default No trustpoints are created by default.
Mode Global Configuration
Usage notes The device certificate associated with first trustpoint added to the application will
be transmitted to remote servers. The certificate received from the remote server
must have an issuer chain that terminates with the root CA certificate for any of the
trustpoints that are associated with the application.
If no trustpoints are specified in the command, the trustpoint list will be
unchanged.
If no log trustpoint is issued without specifying any trustpoints, then all
trustpoints will be disassociated from the application.
Example You can add multiple trustpoints by executing the command multiple times:
awplus# configure terminal
awplus(config)# log trustpoint trustpoint_1
awplus(config)# log trustpoint trustpoint_2
Alternatively, add multiple trustpoints with a single command:
awplus(config)# log trustpoint trustpoint_2 trustpoint_3
Disassociate all trustpoints from the syslog application using the command:
awplus(config)# log trustpoint trustpoint_2 trustpoint_3
Related
commands
log host
show log config
Parameter Description
<trustpoint-list> Specify one or more trustpoints to be added or deleted.
To Next Page
Loading...
Need help?
General
