Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 2991
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
SHOW
ATMF LINKS STATISTICS
show atmf links statistics
Overview This command displays details of the AMF links configured on the device and also
displays statistics about the AMF packet exchanges between the devices.
It is also possible to display the AMF link configuration and packet exchange
statistics for a specified interface.
This command can only be run on AMF master and controller nodes
Syntax
show atmf links statistics [interface [<port-number>]]
Mode User Exec
Example 1 To display AMF link statistics for the whole device, use the command:
device1# show atmf links statistics
Parameter Description
interface Specifies that the command applies to a specific interface
(port) or range of ports. Where both the interface and port
number are unspecified, full statistics (not just those relating to
ports will be displayed.
<port-number> Enter the port number for which statistics are required. A port
range, a static channel or LACP link can also be specified.
Where no port number is specified, statistics will be displayed
for all ports on the device.
Table 58: Sample output from the show atmf links statistics command
ATMF Statistics:

Receive Transmit
--------------------------------------------------------------------------------
Arealink Hello 318 327 
Crosslink Hello 164 167 
Crosslink Hello Domain 89 92 
Crosslink Hello Uplink 86 88 
Hello Link 0 0 
Hello Neighbor 628 630
Hello Stack 0 0 
Hello Gateway 1257 1257 
Database Description 28 28 
Database Request 8 6 
Database Update 66 162 
Database Update Bitmap 0 29 
Database Acknowledge 144 51

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English