43
C613-50631-01 Rev A Command Reference for IE340 Series 2173
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
802.1X Commands
Introduction
Overview 802.1X is an IEEE standard providing a mechanism for authenticating devices
attached to a LAN port or wireless device. Devices wishing to access services
behind a port must authenticate themselves before any Ethernet packets are
allowed to pass through. The protocol is referred to as 802.1X because it was
initially defined in the IEEE standard 802.1X, published in 2001 and revised in 2004
and again as the current 802.1X 2010 standard.
This chapter provides an alphabetical reference of commands used to configure
802.1X port access control. For more information, see the AAA and Port
Authentication_Feature Overview and Configuration Guide.
Command List •“dot1x accounting” on page 2175
•“dot1x authentication” on page 2176
•“debug dot1x” on page 2177
•“dot1x control-direction” on page 2178
•“dot1x eap” on page 2180
•“dot1x eapol-version” on page 2181
•“dot1x initialize interface” on page 2182
•“dot1x initialize supplicant” on page 2183
•“dot1x keytransmit” on page 2184
•“dot1x max-auth-fail” on page 2185
•“dot1x max-reauth-req” on page 2187
•“dot1x port-control” on page 2189
•“dot1x timeout tx-period” on page 2191
•“show debugging dot1x” on page 2193
•“show dot1x” on page 2194
To Next Page
Loading...
Need help?
General
