C613-50631-01 Rev A Command Reference for IE340 Series 966
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
IPV6 COMMANDS
IPV
6 ND ACCEPT-RA-DEFAULT-ROUTES
ipv6 nd accept-ra-default-routes
Overview Use this command to allow accepting and installing of default routes based on a
received RA (Router Advertisement). The default route's destination is set to the
source address of the received RA.
Use the no variant of this command to disable accepting RA-based default routes.
Syntax
ipv6 nd accept-ra-default-routes
no ipv6 nd accept-ra-default-routes
Default RA-based default routes are accepted by default.
Mode Interface Configuration for a VLAN interface or a local loopback interface.
Example To enable RA-based default routes on vlan1, use the following commands:
awplus# configure terminal
awplus(config)# interface vlan1
awplus(config-if)# ipv6 enable
awplus(config-if)# no ipv6 nd accept-ra-pinfo
Related
commands
ipv6 address
ipv6 address autoconfig
ipv6 enable
To Next Page
Loading...
