Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 2202
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
802.1X COMMANDS
SHOW
DOT1X STATISTICS INTERFACE
show dot1x statistics interface
Overview Use this command to show the authentication statistics for the specified interface.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
The output from this command is the same as the output from the show auth
statistics interface command.
Syntax
show dot1x statistics interface <interface-list>
Mode Privileged Exec
Example To display 802.1X authentication statistics for port1.0.2, use the command:
awplus# show dot1x statistics interface port1.0.2
Output Figure 43-2: Example output from show dot1x statistics interface for a port
Command
changes
Version 5.4.9-2.1: command added to AR2050V, AR3050S, and AR4050S
Parameter Description
<interface-list> The interfaces to display information about. An interface-list
can be:
•a VLAN (e.g. vlan2)
• a switchport (e.g. port1.0.4)
• a static channel group (e.g. sa2)
• a dynamic (LACP) channel group (e.g. po2)
• a continuous range of interfaces separated by a hyphen
(e.g. port1.0.1-port1.0.3)
• a comma-separated list (e.g. port1.0.1, port1.0.3-port1.0.4).
Do not mix interface types in a list.
awplus# show dot1x statistics interface port1.0.2
802.1X statistics for interface port1.0.2
EAPOL Frames Rx: 5 - EAPOL Frames Tx: 16
EAPOL Start Frames Rx: 0 - EAPOL Logoff Frames Rx: 0
EAP Rsp/Id Frames Rx: 3 - EAP Response Frames Rx: 2
EAP Req/Id Frames Tx: 8 - EAP Request Frames Tx: 2
Invalid EAPOL Frames Rx: 0 - EAP Length Error Frames Rx: 0
EAPOL Last Frame Version Rx: 1 - EAPOL Last Frame 
Src:00d0.59ab.7037

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English