C613-50631-01 Rev A Command Reference for IE340 Series 2668
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
VRRP COMMANDS
VRRP
VMAC
vrrp vmac
Overview Use this command to enable or disable the VRRP Virtual MAC feature. This feature
is used by VRRP to make the hosts use the virtual MAC address as the physical
hardware address of their gateway.
A VRRP router master will use the virtual MAC address for any ARP responses
associated with the virtual IP address, or any gratuitous ARPs sent on behalf of the
virtual IP address.
All VRRP advertisements are sent using this virtual MAC address as the source MAC
address.
The virtual MAC address has the form 00:00:5e:00:01:<VRID>, where VRID is the ID
of the Virtual Router.
Syntax
vrrp vmac {enable|disable}
Mode Global Configuration
Examples To enable Virtual MAC enter:
awplus# configure terminal
awplus(config)# vrrp vmac enable
To disable Virtual MAC enter:
awplus# configure terminal
awplus(config)# vrrp vmac disable
Related
commands
virtual-ip
virtual-ipv6
To Next Page
Loading...
Need help?
General
