C613-50631-01 Rev A Command Reference for IE340 Series 779
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
UNIDIRECTIONAL LINK DETECTION (UDLD) COMMANDS
UDLD
PORT DISABLE
udld port disable
Overview Use this command to disable UDLD on an interface. This command disables UDLD
on both copper and fiber ports
Use the no variant of this command to allow UDLD on a fiber port.
Syntax
udld port disable
no udld port disable
Default UDLD disable is not set by default.
Usage notes • This command always disables the UDLD feature on a port.
•The udld port command overwrites this command and enables UDLD on an
interface.
• If UDLD has been set globally, using the udld enable command, then
AlliedWare Plus ignores the no udld port command on a fiber interface.
Mode Interface Configuration
Example To disable UDLD on port1.0.1, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# udld port disable
To enable UDLD on port1.0.1, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# no udld port disable
Related
commands
udld enable
udld port
show udld port
To Next Page
Loading...
Need help?
General
