C613-50631-01 Rev A Command Reference for IE340 Series 1882
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-SMV6 COMMANDS
IPV
6 PIM SPT-THRESHOLD
ipv6 pim spt-threshold
Overview This command turns on the ability for the last-hop PIM-SMv6 router to switch to
SPT (shortest-path tree).
The no variant of this command turns off the ability for the last-hop PIM-SMv6
router to switch to SPT.
NOTE: The switching to SPT happens either at the receiving of the first data packet, or
not at all; it is not rate-based.
Syntax
ipv6 pim spt-threshold
no ipv6 pim spt-threshold
Mode Global Configuration
Examples To enable the last-hop PIM-SMv6 router to switch to SPT, use the following
commands:
awplus# configure terminal
awplus(config)# ipv6 forwarding
awplus(config)# ipv6 multicast-routing
awplus(config)# ipv6 pim spt-threshold
To stop the last-hop PIM-SMv6 router from being able to switch to SPT, use the
following commands:
awplus# configure terminal
awplus(config)# no ipv6 pim spt-threshold
Related
commands
ipv6 pim spt-threshold group-list
To Next Page
Loading...
Need help?
General
