C613-50631-01 Rev A Command Reference for IE340 Series 1517
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
BGP AND BGP4+ COMMANDS
NEIGHBOR
VERSION (BGP ONLY)
neighbor version (BGP only)
Overview Use this command to configure the device to accept only a particular BGP version.
Use the no variant of this command to use the default BGP version (version 4).
Syntax
neighbor <neighborid> version <version>
no neighbor <neighborid> version
Mode Router Configuration or IPv4 Address Family Configuration
Usage notes By default, the system uses BGP version 4 and on request dynamically negotiates
down to version 2. Using this command disables the router’s version-negotiation
capability and forces the router to use only a specified version with the neighbor.
Parameter Description
<neighborid>
{<ip-address>
|<peer-group>
}<ip-address> The address of an IPv4 BGP neighbor, in dotted
decimal notation A.B.C.D.
<peer-group> Enter the name of an existing peer-group. For
information on how to create peer groups,
refer to the neighbor peer-group (add a
neighbor) command, and neighbor route-map
command. When this parameter is used with
this command, the command applies on all
peers in the specified group.
<version> {4} Specifies the BGP version number.
To Next Page
Loading...
Need help?
General
