C613-50631-01 Rev A Command Reference for IE340 Series 1138
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
OSPF COMMANDS
HOST
AREA
host area
Overview This command configures a stub host entry belonging to a particular area. You can
use this command to advertise specific host routes in the router-LSA as stub link.
Since stub host belongs to the specified router, specifying cost is optional.
The no variant of this command removes the host area configuration.
Syntax
host <ip-address> area <area-id> [cost <0-65535>]
no host <ip-address> area <area-id> [cost <0-65535>]
Default By default, no host entry is configured.
Mode Router Configuration
Example
awplus# configure terminal
awplus(config)# router ospf 100
awplus(config-router)# host 172.16.10.100 area 1
awplus(config-router)# host 172.16.10.101 area 2 cost 10
Parameter Description
<ip-address> The IPv4 address of the host, in dotted decimal notation.
<area-id> The OSPF area ID of the transit area that configuring the stub
host entry for. Use one of the following formats:
• dotted decimal format, e.g. 0.0.1.2.
• normal decimal format in the range <0-4294967295>, e.g.
258.
cost <0-65535> The cost for the stub host entry.
To Next Page
Loading...
Need help?
General
