Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 1198
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
OSPF COMMANDS
SHOW
IP OSPF ROUTE
show ip ospf route
Overview Use this command to display the OSPF routing table. Include the ospf-id
parameter with this command to display the OSPF routing table for specified
instances.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ip ospf [<ospf-id>] route
Mode User Exec and Privileged Exec
Examples To display the OSPF routing table, use the command:
awplus# show ip ospf route
Output Figure 28-21: Example output from the show ip ospf route command for a
specific process
Parameter Description
<ospf-id> <0-65535> The ID of the router process for which information will be
displayed. If this parameter is included, only the information for this
specified routing process is displayed.
awplus#show ip ospf route

OSPF process 1:
Codes: C - connected, D - Discard, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2

O 10.10.0.0/24 [10] is directly connected, vlan1, Area 0.0.0.0
O 10.10.11.0/24 [10] is directly connected, vlan2, Area 0.0.0.0
O 10.10.11.100/32 [10] is directly connected, lo, Area 0.0.0.0
E2 10.15.0.0/24 [10/50] via 10.10.0.1, vlan1
IA 172.16.10.0/24 [30] via 10.10.11.50, vlan2, Area 0.0.0.0
E2 192.168.0.0/16 [10/20] via 10.10.11.50, vlan2

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English