C613-50631-01 Rev A Command Reference for IE340 Series 1369
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
BGP AND BGP4+ COMMANDS
CLEAR
IP BGP (IPV4) (BGP ONLY)
clear ip bgp (IPv4) (BGP only)
Overview Use this command to reset the IPv4 BGP connection to the peer specified by the IP
address.
Syntax [BGP]
clear ip bgp <ipv4-addr> [in [prefix-filter]|out|soft [in|out]]
Mode [BGP] Privileged Exec
Examples [BGP] To clear the BGP connection to the peer at IPv4 address 192.168.1.1 and clear all
incoming routes, use the following command:
awplus# clear ip bgp 192.168.1.1 in
Command
changes
Added to AlliedWare Plus prior to 5.4.6-1
Version 5.4.6-2.1: VRF-lite support added to BGP for AR-series products
Version 5.4.7-2.1: BGP support added for x510 and x550 series
Version 5.4.7-2.4: BGP support added for IE300 series
Parameter Description
<ipv4-addr> Specifies the IPv4 address of the neighbor whose connection is to
be reset, entered in the form A.B.C.D.
in Indicates that incoming advertised routes will be cleared.
prefix-filter Specifies that a prefix-list will be sent, by the ORF mechanism, to
those neighbors with which the ORF capability has been
negotiated. The neighbors will be triggered to resend updates,
which match the prefix-list filter, to the local router. The local
router will then perform a soft reconfiguration.
out Indicates that outgoing advertised routes will be cleared.
soft in Soft inbound reset causes the neighbors to resend all their
updates to the local switch, without resetting the connection or
clearing the entries in the local switch. So, the local switch stores
new updates, and uses them to systematically replace existing
table entries. This process can use a considerable amount of
memory.
soft out Soft outbound reset causes the switch to simply resend all its
updates to the specified neighbor(s), without resetting the
connection, or clearing table entries.
To Next Page
Loading...
Need help?
General
