26
C613-50631-01 Rev A Command Reference for IE340 Series 1019
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
RIP Commands
Introduction
Overview This chapter provides an alphabetical reference of commands used to configure
RIP.
For information about configuring RIP, see the RIP Feature Overview and
Configuration Guide.
Command List •“accept-lifetime” on page 1021
•“alliedware-behavior” on page 1023
•“cisco-metric-behavior (RIP)” on page 1025
•“clear ip rip route” on page 1026
•“debug rip” on page 1027
•“default-information originate (RIP)” on page 1028
•“default-metric (RIP)” on page 1029
•“distance (RIP)” on page 1030
•“distribute-list (RIP)” on page 1031
•“fullupdate (RIP)” on page 1032
•“ip summary-address rip” on page 1033
•“ip prefix-list” on page 1034
•“ip rip authentication key-chain” on page 1036
•“ip rip authentication mode” on page 1038
•“ip rip authentication string” on page 1040
•“ip rip receive-packet” on page 1042
•“ip rip receive version” on page 1043
•“ip rip send-packet” on page 1044
To Next Page
Loading...
Need help?
General
