Allied Telesis IE340 Series - ipv6 pim ignore-rp-set-priority

C613-50631-01 Rev A Command Reference for IE340 Series 1867
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-SMV6 COMMANDS
IPV
6 PIM IGNORE-RP-SET-PRIORITY
ipv6 pim ignore-rp-set-priority
Overview Use this command to ignore the RP-SET priority value, and use only the hashing
mechanism for RP selection.
Use the no variant of this command to disable this setting.
Syntax
ipv6 pim ignore-rp-set-priority
no ipv6 pim ignore-rp-set-priority
Mode Global Configuration
Usage This command is used to inter-operate with older Cisco IOS versions.
Example
awplus# configure terminal
awplus(config)# ipv6 forwarding
awplus(config)# ipv6 multicast-routing
awplus(config)# ipv6 pim ignore-rp-set-priority
awplus# configure terminal
awplus(config)# no ipv6 pim ignore-rp-set-priority