C613-50631-01 Rev A Command Reference for IE340 Series 1323
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
BGP AND BGP4+ COMMANDS
BGP
BESTPATH MED REMOVE-SEND-MED
bgp bestpath med remove-send-med
Overview This command removes the Multi Exit Discriminator (MED) attribute from the
update messages sent by the BGP speaker to its peers. However, the local BGP
speaker will consider the MED attribute received from other peers during the
decision and route selection process, unless specified not to by the bgp bestpath
med remove-recv-med command.
Use the no variant of this command to disable this feature.
Syntax
bgp bestpath med remove-send-med
no bgp bestpath med remove-send-med
Mode Router Configuration
Example To enable the remove-send-med feature on the BGP speaker belonging to the
Autonomous System (AS) 100, enter the command:
awplus# configure terminal
awplus(config)# router bgp 100
awplus(config-router)# bgp bestpath med remove-send-med
Related
commands
bgp bestpath med remove-recv-med
Command
changes
Added to AlliedWare Plus prior to 5.4.6-1
Version 5.4.7-2.1: BGP support added for x510 and x550 series
Version 5.4.7-2.4: BGP support added for IE300 series
To Next Page
Loading...
Need help?
General
