C613-50631-01 Rev A Command Reference for IE340 Series 1632
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
ROUTE MAP COMMANDS
SET
EXTCOMMUNITY
set extcommunity
Overview Use this command to add an extended community set clause to a route map entry.
A route map entry can have a route target extended community set clause, a
site-of-origin extended community set clause, or both.
When a BGP update message matches the route map entry, the device sets the
update’s extended community attribute to the specified value or values.
Use the no variant of this command to remove the set clause.
Syntax
set extcommunity {rt|soo} <extcomm-number>
no set extcommunity {rt|soo} [<extcomm-number>]
Mode Route-map Configuration
Usage notes This command is valid for BGP update messages only.
Examples To use entry 3 of the route map called rmap1 to set the route target extended
community attribute to 06:01, use the commands:
awplus# configure terminal
awplus(config)# route-map rmap1 permit 3
awplus(config-route-map)# set extcommunity rt 06:01
To instead specify the extended community number in dotted decimal notation,
use the command:
awplus# configure terminal
awplus(config)# route-map rmap1 permit 3
awplus(config-route-map)# set extcommunity rt 0.0.0.6:01
To use entry 3 of the route map called rmap1 to set the site-of-origin extended
community attribute to 06:01, use the commands:
awplus# configure terminal
awplus(config)# route-map rmap1 permit 3
awplus(config-route-map)# set extcommunity soo 06:01
Parameter Description
rt Configure a route target extended community. This consists
of routers that will receive matching routes.
soo Configure a site-of-origin extended community. This
consists of routers that will inject matching routes into BGP.
<extcomm-number> The extended community number, in the format AA:NN or
IPADD:N.
To Next Page
Loading...
Need help?
General
