C613-50631-01 Rev A Command Reference for IE340 Series 274
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SYSTEM CONFIGURATION AND MONITORING COMMANDS
ECOFRIENDLY
LED
ecofriendly led
Overview Use this command to enable the eco-friendly LED (Light Emitting Diode) feature,
which turns off power to the port LEDs.
Use the no variant of this command to disable the eco-friendly LED feature.
Syntax
ecofriendly led
no ecofriendly led
Default The eco-friendly LED feature is disabled by default.
Mode Global Configuration
Usage notes While the eco-friendly LED feature is enabled, a port’s LED will not change if the
port’s status changes. Instead, the LED will stay turned off. When you disable the
eco-friendly feature again, that will restore power to the port LEDs. The LEDs will
correctly show the current state of the ports, even if that state changed while the
LEDs were off.
For an example of how to configure a trigger to turn off power to port LEDs, see the
Triggers Feature Overview and Configuration Guide.
Examples To enable the eco-friendly LED feature which turns off power to all port LEDs, use
the following commands:
awplus# configure terminal
awplus(config)# ecofriendly led
To disable the eco-friendly LED feature, use the following commands:
awplus# configure terminal
awplus(config)# no ecofriendly led
Related
commands
ecofriendly lpi
show ecofriendly
To Next Page
Loading...
Need help?
General
