C613-50631-01 Rev A Command Reference for IE340 Series 2205
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
802.1X COMMANDS
SHOW
DOT1X SUPPLICANT INTERFACE
show dot1x supplicant interface
Overview Use this command to show the supplicant state of the authentication mode set for
the interface.
This command shows a summary when the optional brief parameter is used.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare_Plus” Feature Overview and Configuration Guide.
Syntax
show dot1x supplicant interface <interface-list> [brief]
Mode Privileged Exec
Examples See sample output below showing the supplicant on the interface port1.0.2:
awplus# show dot1x supplicant interface port1.0.2
Parameter Description
<interface-list> The interfaces to display information about. An interface-list
can be:
• a VLAN (e.g. vlan2)
• a switchport (e.g. port1.0.4)
• a static channel group (e.g. sa2)
• a dynamic (LACP) channel group (e.g. po2)
• a continuous range of interfaces separated by a hyphen
(e.g. port1.0.1-port1.0.3)
• a comma-separated list (e.g. port1.0.1,
port1.0.3-port1.0.4). Do not mix interface types in a list.
brief Brief summary of the Supplicant state.
To Next Page
Loading...
Need help?
General
