C613-50631-01 Rev A Command Reference for IE340 Series 145
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
FILE AND CONFIGURATION MANAGEMENT COMMANDS
BOOT
SYSTEM
boot system
Overview Use this command to set the release file to load during the next boot cycle.
Use the no variant of this command to stop specifying a primary release file to boot
from. If the device boots up with no release file set, it will use autoboot or the
backup release file if either of those are configured. You can also use the boot
menu to select a release file source. To access the boot menu, type Ctrl-B at
bootup.
Syntax
boot system <filepath-filename>
no boot system
Mode Global Configuration
Usage notes You can only specify that the release file is on a USB storage device if there is a
backup release file already specified in flash. If you attempt to set the release file
on a USB storage device and a backup release file is not specified in flash, the
following error message is displayed:
Examples To boot up with the release file IE340-5.5.3-0.1.rel the next time the device boots
up, when the release file is stored on the device’s flash filesystem, use the
commands:
awplus# configure terminal
awplus(config)# boot system flash:/IE340-5.5.3-0.1.rel
To run the release file IE340-5.5.3-0.1.rel the next time the device boots up, when
the release file is stored on a USB storage device, use the commands:
awplus# configure terminal
awplus(config)# boot system usb:/IE340-5.5.3-0.1.rel
Parameter Description
<filepath-filename> Filepath and name of a release file.
The specified release file must exist and must be stored
in the root directory of the specified filesystem.
Valid release files must have a .rel extension.
% A backup boot image must be set before setting a current boot ď€
image on USB storage device
To Next Page
Loading...
Need help?
General
