C613-50631-01 Rev A Command Reference for IE340 Series 2148
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
QOS COMMANDS
SERVICE
-POLICY INPUT
service-policy input
Overview Use this command to apply a policy-map to the input of an interface.
Use the no variant of this command to remove a policy-map and interface
association.
Syntax
service-policy input <policy-map>
no service-policy input <policy-map>
Mode Interface Configuration
Usage notes This command can be applied to switch ports or static channel groups, but not to
dynamic (LACP) channel groups.
Example To apply a policy-map named pmap1 to interface port1.0.2, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
wplus(config-if)# service-policy input pmap1
Parameter Description
<policy-map> Policy map name that will be applied to the input.
To Next Page
Loading...
Need help?
General
