C613-50631-01 Rev A Command Reference for IE340 Series 665
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
VLAN COMMANDS
SWITCHPORT
MODE PRIVATE-VLAN TRUNK SECONDARY
switchport mode private-vlan trunk
secondary
Overview Use this command to enable a port in trunk mode to be a secondary port for
isolated VLANs.
NOTE: Private VLAN trunk ports are not supported by the current AlliedWare Plus GVRP
implementation. Private VLAN trunk ports and GVRP are mutually exclusive.
Use the no variant of this command to remove a port in trunk mode as a secondary
port for isolated VLANs.
Syntax
switchport mode private-vlan trunk secondary group <group-id>
no switchport mode private-vlan trunk secondary
Default By default, a port in trunk mode is disabled as a secondary port.
When a port in trunk mode is enabled to be a secondary port for isolated VLANs,
by default it will have a native VLAN of none (no native VLAN specified).
Mode Interface Configuration
Usage notes A port must be put in trunk mode with switchport mode trunk command before
the port is enabled as a secondary port in trunk mode.
To add VLANs to be trunked over the secondary port use the switchport trunk
allowed vlan command. These must be isolated VLANs and must exist on the
associated promiscuous port.
To configure the native VLAN for the secondary port, use the switchport trunk
native vlan command. The native VLAN must be an isolated VLAN and must exist
on the associated promiscuous port.
Parameter Description
<group-id> The group ID is a numeric value in the range 1 to 32 that is
used to associate a secondary port with its promiscuous port.
To Next Page
Loading...
Need help?
General
