C613-50631-01 Rev A Command Reference for IE340 Series 3222
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
LLDP COMMANDS
LLDP
MED-NOTIFICATIONS
lldp med-notifications
Overview Use this command to enable LLDP to send LLDP-MED Topology Change Detected
SNMP notifications relating to the specified ports. The switch sends an SNMP event
notification when a new LLDP-MED compliant IP Telephony device is connected to
or disconnected from a port on the switch.
Use the no variant of this command to disable the sending of LLDP-MED Topology
Change Detected notifications relating to the specified ports.
Syntax
lldp med-notifications
no lldp med-notifications
Default The sending of LLDP-MED notifications is disabled by default.
Mode Interface Configuration
Examples To enable the sending of LLDP-MED Topology Change Detected notifications
relating to ports port1.0.1 and port1.0.2, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1,port1.0.2
awplus(config-if)# lldp med-notifications
To disable the sending of LLDP-MED notifications relating to port1.0.1 and
port1.0.2, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1,port1.0.2
awplus(config-if)# no lldp med-notifications
Related
commands
lldp notification-interval
lldp notifications
snmp-server enable trap
show lldp interface
Command
changes
Version 5.4.8-2.1: Command added to AR2050V, AR3050S, AR4050S
To Next Page
Loading...
