Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 3445
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SFLOW COMMANDS
SHOW
SFLOW
show sflow
Overview This command displays non-port-specific sFlow agent configuration and
operational status.
Syntax
show sflow
Mode Privileged Exec
Example To display sFlow configuration and operational status, use the command:
awplus# show sflow
Output
Table 1: Example output from the show sflow command
sFlow Agent Configuration: Default Values
sFlow Admin Status ........ Disabled [Disabled]
sFlow Agent Address ....... [not set] [not set]
Collector Address ......... 0.0.0.0 [0.0.0.0]
Collector UDP Port ........ 6343 [6343]
Tx Max Datagram Size ...... 1200 [1400]

sFlow Agent Status:
Polling/sampling/Tx ....... Inactive because:
- sFlow is disabled
- Agent Addr is not set
- Collector Addr is 0.0.0.0
- Polling & sampling disabled
on all ports
Table 2: Parameters in the output of the show sflow command
Output Parameter Description
sFlow Admin
Status
Whether sFlow agent operation is administratively
enabled.
sFlow Agent
Address
The sFlow agent IPv4 or IPv6 address for the device. sFlow
is rendered inactive whenever the agent address is not set.
Collector Address The IPv4 or IPv6 collector address to which sFlow
datagrams are sent. sFlow is rendered inactive whenever
the collector address is set to 0.0.0.0 or 0:0::0.0.
Collector UDP
Port
The UDP port on the collector to which sFlow datagrams
are sent.

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English