C613-50631-01 Rev A Command Reference for IE340 Series 1167
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
OSPF COMMANDS
PASSIVE
-INTERFACE (OSPF)
passive-interface (OSPF)
Overview Use this command to suppress the sending of Hello packets on all interfaces, or on
a specified interface. If you use the passive-interface command without the
optional parameters then all interfaces are put into passive mode.
Use the no variant of this command to allow the sending of Hello packets on all
interfaces, or on the specified interface. If you use the no variant of this command
without the optional parameters then all interfaces are removed from passive
mode.
Syntax
passive-interface [<interface>] [<ip-address>]
no passive-interface [<interface>] [<ip-address>]
Mode Router Configuration
Usage notes Configure an interface to be passive if you wish its connected route to be treated
as an OSPF route (rather than an AS-external route), but do not wish to actually
exchange any OSPF packets via this interface.
Examples To configure passive interface mode on all interfaces, enter the following
commands:
awplus(config)# router ospf 100
awplus(config-router)# passive-interface
To configure passive interface mode on the local loopback interface, enter the
following commands:
awplus(config)# router ospf 100
awplus(config-router)# passive-interface lo
To remove passive interface mode on all interfaces, enter the following
commands:
awplus(config)# router ospf 100
awplus(config-router)# no passive-interface
Parameter Description
<interface> The name of the interface.
<ip-address> IP address of the interface, entered in the form A.B.C.D.
To Next Page
Loading...
Need help?
General
