C613-50631-01 Rev A Command Reference for IE340 Series 823
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
POWER OVER ETHERNET COMMANDS
POWER
-INLINE WATTAGE MAX
power-inline wattage max
Overview Use this command to specify the maximum system-wide power to be delivered by
the switch. This is useful if the switch is powered by a system that cannot deliver
the default wattage.
Use the no variant of this command to return the maximum power to the default
value.
Syntax
power-inline wattage max <watts>
no power inline wattage
Default The switch’s system limit, which is 240 watts
Mode Global Configuration
Example To set the switch’s maximum wattage to 90W, use the commands:
awplus# configure terminal
awplus(config)# power inline wattage max 90
Related
commands
show power-inline
Command
changes
Version 5.4.6-1.1: command added
Parameter Description
max <watts> The maximum number of watts to be distributed by the device,
from 1 to 240. Note that you cannot set the wattage to be higher
than the switch’s system limit of 240W, which is the default value.
To Next Page
Loading...
Need help?
General
