Allied Telesis IE340 Series - service dhcp-server

C613-50631-01 Rev A Command Reference for IE340 Series 3085
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
DYNAMIC HOST CONFIGURATION PROTOCOL (DHCP) COMMANDS
SERVICE
DHCP-SERVER
service dhcp-server
Overview This command enables the DHCP server on your device. The server then listens for
DHCP requests on all IP interfaces. It will not run if there are no IP interfaces
configured.
The no variant of this command disables the DHCP server.
Syntax
service dhcp-server
no service dhcp-server
Mode Global Configuration
Example To enable the DHCP server, use the commands:
awplus# configure terminal
awplus(config)# service dhcp-server
Related
commands
ip dhcp pool
show ip dhcp server summary
subnet-mask