C613-50631-01 Rev A Command Reference for IE340 Series 2792
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
ATMF
AREA
atmf area
Overview This command creates an AMF area and gives it a name and ID number.
Use the no variant of this command to remove the AMF area.
This command is only valid on AMF controllers, master nodes and gateway nodes.
Syntax
atmf area <area-name> id <1-4094> [local]
no atmf area <area-name>
Mode Global Configuration
Usage notes This command enables you to divide your AMF network into areas. Each area is
managed by at least one AMF master node. Each area can have up to 120 nodes,
depending on the license installed on that area’s master node.
The whole AMF network is managed by up to 8 AMF controllers. Each AMF
controller can communicate with multiple areas. The number of areas supported
on a controller depends on the license installed on that controller.
You must give each area in an AMF network a unique name and ID number.
Only one local area can be configured on a device. You must specify a local area on
each controller, remote AMF master, and gateway node.
Example To create the AMF area named New-Zealand, with an ID of 1, and specify that it is
the local area, use the command:
controller-1(config)# atmf area New-Zealand id 1 local
To configure a remote area named Auckland, with an ID of 100, use the command:
controller-1(config)# atmf area Auckland id 100
Parameter Description
<area-name> The AMF area name. The area name can be up to 15
characters long. Valid characters are: ď€
a..zď€
A..Zď€
0..9ď€
-ď€
_
Names are case sensitive and must be unique within an
AMF network. The name cannot be the word “local” or an
abbreviation of the word “local” (such as “l”, “lo” etc.).
<1-4094> An ID number that uniquely identifies this area.
local Set the area to be the local area. The local area contains the
device you are configuring.
To Next Page
Loading...
Need help?
General
