27
C613-50631-01 Rev A Command Reference for IE340 Series 1073
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
RIPng for IPv6
Commands
Introduction
Overview This chapter contains RIPng commands. RIPng (Routing Information Protocol next
generation) is an extension of RIPv2 to support IPv6. RFC 2080 specifies RIPng. The
differences between RIPv2 and RIPng are:
• RIPng does not support RIP updates authentication
• RIPng does not allow the attachment of arbitrary tags to routes
• RIPng requires the encoding of the next-hop for a set of routes
For more information, see the RIPng Feature Overview and Configuration Guide.
Command List •“aggregate-address (IPv6 RIPng)” on page 1075
•“clear ipv6 rip route” on page 1076
•“debug ipv6 rip” on page 1077
•“default-information originate (IPv6 RIPng)” on page 1078
•“default-metric (IPv6 RIPng)” on page 1079
•“distribute-list (IPv6 RIPng)” on page 1080
•“ipv6 prefix-list” on page 1081
•“ipv6 rip metric-offset” on page 1083
•“ipv6 rip split-horizon” on page 1085
•“ipv6 router rip” on page 1086
•“neighbor (IPv6 RIPng)” on page 1087
•“offset-list (IPv6 RIPng)” on page 1088
•“passive-interface (IPv6 RIPng)” on page 1089
•“recv-buffer-size (IPv6 RIPng)” on page 1090
•“redistribute (IPv6 RIPng)” on page 1091
To Next Page
Loading...
Need help?
General
