C613-50631-01 Rev A Command Reference for IE340 Series 330
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PLUGGABLES AND CABLING COMMANDS
CLEAR
FIBER-MONITORING INTERFACE
clear fiber-monitoring interface
Overview Use this command to clear the Active Fiber Monitoring state of a port. It clears the
alarm, baseline and history and starts monitoring from the beginning. It does not
change the configuration.
Syntax
clear fiber-monitoring interface <port>
Default n/a
Mode Privileged Exec
Usage notes Normally, you do not need to clear the Active Fiber Monitoring state of a port. If the
issue resolves itself and the monitored optical power returns to the baseline, the
alarm clears automatically.
However, you may need to clear the Active Fiber Monitoring state if the optical
power level reduces for a known reason, causing the port to be stuck in the alarm
state. In this situation, the alarm will not clear automatically, because Active Fiber
Monitoring does not update the baseline when the port is in the alarm state, for
security reasons.
Example To clear the Active Fiber Monitoring state for interface port1.0.1, use the
command:
awplus# clear fiber-monitoring interface port1.0.1
Related
commands
show system fiber-monitoring
Command
changes
Version 5.4.8-0.2: command added
Parameter Description
<port> The name of the port to reset Active Fiber Monitoring on.
To Next Page
Loading...
Need help?
General
