Allied Telesis IE340 Series - PIM-SM Commands; Introduction

35
C613-50631-01 Rev A Command Reference for IE340 Series 1786
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-SM Commands
Introduction
Overview This chapter provides an alphabetical reference of PIM-SM commands. For
commands common to PIM-SM and PIM-DM, see the Multicast Commands
chapter.
Command List •“clear ip pim sparse-mode bsr rp-set *” on page 1788
•“clear ip pim sparse-mode packet statistics” on page 1789
•“clear ip mroute pim sparse-mode” on page 1790
•“debug pim sparse-mode” on page 1791
•“debug pim sparse-mode timer” on page 1792
•“ip multicast allow-register-fragments” on page 1794
•“ip pim accept-register list” on page 1795
•“ip pim anycast-rp” on page 1796
•“ip pim bsr-border” on page 1797
•“ip pim bsr-candidate” on page 1798
•“ip pim cisco-register-checksum” on page 1799
•“ip pim cisco-register-checksum group-list” on page 1800
•“ip pim crp-cisco-prefix” on page 1801
•“ip pim dr-priority” on page 1802
•“ip pim exclude-genid” on page 1803
•“ip pim ext-srcs-directly-connected” on page 1804
•“ip pim hello-holdtime (PIM-SM)” on page 1805
•“ip pim hello-interval (PIM-SM)” on page 1806
•“ip pim ignore-rp-set-priority” on page 1807