Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 3471
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
MODBUS COMMANDS
SHOW
SCADA MODBUS TCP SERVER CONNECTIONS
show scada modbus tcp server connections
Overview Use this command to display the information and statistics of the currently
connected clients to a MODBUS TCP server.
Syntax
show scada modbus tcp server connections
Mode User Exec and Privileged Exec
Example To display the information and statistics of the currently connected clients to a
MODBUS TCP server, use the following commands:
awplus# configure terminal
awplus(config)# show scada modbus tcp server connections
Output Figure 71-1: Example output from show scada modbus tcp server
connections
Related
commands
scada modbus tcp server port
scada modbus tcp server connection
show scada modbus tcp server
clear scada modbus tcp server connection
clear scada modbus tcp server statistics
SCADA MODBUS Client Information
Connected client 1
IP address : 192.168.2.200
Port : 37509
Uptime : 22
Statistics:
Read Requests:
coils : 0
discrete inputs : 0
holding registers : 2
input registers : 0
Write Requests:
single coil : 0
single register : 0
multiple coils : 0
multiple registers : 0

Other Requests : 0
Exceptions:
illegal function : 0
illegal data address : 0
illegal data value : 0
slave device failure : 0
...

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English