Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 2686
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
ETHERNET PROTECTION SWITCHED RING (EPSRING™) COMMANDS
SHOW
EPSR
show epsr
Overview This command displays information about all EPSR instances.
Syntax
show epsr
Mode User Exec and Privileged Exec
Example To show the current settings of all EPSR instances, use the command:
awplus# show epsr
Output:
non-superloop
topology
The following examples show the output display for a non-superloop topology
network.
Table 1: Example output from the show epsr command run on a transit node
EPSR Information
------------------------------------------------------------
Name ........................ test2
Mode .......................... Transit
Status ........................ Enabled
State ......................... Links-Up
Control Vlan .................. 2
Data VLAN(s) .................. 10
Interface Mode ................ Ports Only
First Port .................... port1.0.1
First Port Status ............. Down 
First Port Direction .......... Unknown
Second Port ................... port1.0.2
Second Port Status ............ Down 
Second Port Direction ......... Unknown
Trap .......................... Enabled
Master Node ................... Unknown
Enhanced Recovery ............. Disabled
------------------------------------------------------------

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English