Allied Telesis IE340 Series - show atmf area summary

C613-50631-01 Rev A Command Reference for IE340 Series 2948
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
SHOW
ATMF AREA SUMMARY
show atmf area summary
Overview Use this command to display a summary of IPv6 addresses used by AMF, for one or
all of the areas controlled by an AMF controller.
Syntax
show atmf area summary [<area-name>]
Mode Privileged Exec
Example 1 To show a summary of IPv6 addresses used by AMF, for all of the areas controlled
by controller-1, use the command:
controller-1# show atmf area summary
The following figure shows example output from running this command.
Related
commands
show atmf area
show atmf area nodes
show atmf area nodes-detail
Parameter Description
<area-name> Displays information for the specified area only.
Table 72: Output from the show atmf area summary command
controller-1#show atmf area summary

ATMF Area Summary Information: 

Management Information 
Local IPv6 Address : fd00:4154:4d46:1::15 

Area Information 
Area Name : NZ (Local) 
Area ID : 1 
Area Master IPv6 Address : - 

Area Name : Wellington 
Area ID : 2 
Area Master IPv6 Address : fd00:4154:4d46:2::149 

Area Name : Canterbury 
Area ID : 3 
Area Master IPv6 Address : fd00:4154:4d46:3::f 

Area Name : Auckland 
Area ID : 100 
Area Master IPv6 Address : fd00:4154:4d46:64::17 
Interface : vlink2000