C613-50631-01 Rev A Command Reference for IE340 Series 3190
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SNMP COMMANDS
SNMP
-SERVER
snmp-server
Overview Use this command to enable the SNMP agent (server) on the device. The SNMP
agent receives and processes SNMP packets sent to the device, and generates
notifications (traps) that have been enabled by the snmp-server enable trap
command.
Use the no variant of this command to disable the SNMP agent on the device.
When SNMP is disabled, SNMP packets received by the device are discarded, and
no notifications are generated. This does not remove any existing SNMP
configuration.
Syntax
snmp-server [ip|ipv6]
no snmp-server [ip|ipv6]
Default By default, the SNMP agent is enabled for both IPv4 and IPv6. If neither the ip
parameter nor the ipv6 parameter is specified for this command, then SNMP is
enabled or disabled for both IPv4 and IPv6.
Mode Global Configuration
Examples To enable SNMP on the device for both IPv4 and IPv6, use the commands:
awplus# configure terminal
awplus(config)# snmp-server
To enable the SNMP agent for IPv4 on the device, use the commands:
awplus# configure terminal
awplus(config)# snmp-server ip
To disable the SNMP agent for both IPv4 and IPv6 on the device, use the
commands:
awplus# configure terminal
awplus(config)# no snmp-server
To disable the SNMP agent for IPv4, use the commands:
awplus(config)# no snmp-server ipv4
Parameter Description
ip Enable or disable the SNMP agent for IPv4.
ipv6 Enable or disable the SNMP agent for IPv6.
To Next Page
Loading...
Need help?
General
