Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 1099
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
RIPNG FOR IPV6 COMMANDS
SHOW
IPV6 RIP INTERFACE
show ipv6 rip interface
Overview Use this command to display information about the RIPng interfaces. You can
specify an interface name to display information about a specific interface.
For information on filtering and saving command output, see the “Getting_Started
with AlliedWare Plus” Feature Overview and Configuration_Guide.
Syntax
show ipv6 rip interface [<interface>]
Mode User Exec and Privileged Exec
Example To display RIPng interface information, use the following command:
awplus# show ipv6 rip interface
Output Figure 27-4: Example output from the show ipv6 rip interface command
Parameter Description
<interface> The interface to display information about.
lo is up, line protocol is up
RIPng is not enabled on this interface
vlan1 is up, line protocol is up
RIPng is not enabled on this interface
vlan2 is down, line protocol is down
RIPng is not enabled on this interface
vlan3 is up, line protocol is up
Routing Protocol: RIPng
Passive interface: Disabled
Split horizon: Enabled with Poisoned Reversed
IP interface address:
2001:db8:1::1/64
2001:db8:1::2/64
...

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English