C613-50631-01 Rev A Command Reference for IE340 Series 1726
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
MLD AND MLD SNOOPING COMMANDS
IPV
6 MLD ROBUSTNESS-VARIABLE
ipv6 mld robustness-variable
Overview Use this command to change the robustness variable value on an interface.
Use the no variant of this command to return to the default on an interface.
Syntax
ipv6 mld robustness-variable <value>
no ipv6 mld robustness-variable
Default The default robustness variable value is 2.
Mode Interface Configuration for a specified VLAN interface or a range of VLAN
interfaces.
Usage This command applies to interfaces configured for MLD Layer 3 multicast
protocols.
Example The following example changes the robustness variable value to 3:
awplus# configure terminal
awplus(config)# ipv6 forwarding
awplus(config)# ipv6 multicast-routing
awplus(config)# interface vlan2
awplus(config-if)# ipv6 enable
awplus(config-if)# ipv6 mld robustness-variable 3
Parameter Description
<value> Valid values are from 1 to 7.
To Next Page
Loading...
Need help?
General
