C613-50631-01 Rev A Command Reference for IE340 Series 735
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SPANNING TREE COMMANDS
SPANNING
-TREE EDGEPORT (RSTP AND MSTP)
spanning-tree edgeport (RSTP and MSTP)
Overview Use this command to set a port as an edge-port.
Use this command for RSTP or MSTP.
This command has the same effect as the spanning-tree portfast (STP) command,
but the configuration displays differently in the output of some show commands.
Use the no variant of this command to set a port to its default state (not an
edge-port).
Syntax
spanning-tree edgeport
no spanning-tree edgeport
Default Not an edge port.
Mode Interface Configuration
Usage notes Use this command on a switch port connected to a LAN that has no other bridges
attached. If a BPDU is received on the port that indicates that another bridge is
connected to the LAN, then the port is no longer treated as an edge port.
Example
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# spanning-tree edgeport
Related
commands
spanning-tree autoedge (RSTP and MSTP)
To Next Page
Loading...
Need help?
General
