C613-50631-01 Rev A Command Reference for IE340 Series 1886
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-SMV6 COMMANDS
SERVICE
PIM6
service pim6
Overview Use this command to enable IPv6 PIM sparse mode services.
Use the no version of the command to disable unused IPv6 PIM sparse mode
services.
Syntax
service pim6
no service pim6
Default Enabled
Mode Global Configuration
Usage notes Sometimes it may be desirable to disable unused services, in order to reduce
memory use.
Disabling the PIM services will only take effect after you save the configuration and
restart the device.
Example To disable the IPv6 PIM sparse mode service, use the commands:
awplus# configure terminal
awplus(config)# no service pim6
Output Figure 36-2: Example output from no service pim6
Command
changes
Version 5.5.0-0.1: command added
awplus(config)#no service pim6ď€
% Save the config and restart the device for this change to take
effect
To Next Page
Loading...
Need help?
General
