C613-50631-01 Rev A Command Reference for IE340 Series 2099
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
IPV6 SOFTWARE ACCESS CONTROL LIST (ACL) COMMANDS
(IPV6 ACCESS-LIST STANDARD FILTER)
(ipv6 access-list standard filter)
Overview Use this ACL filter to add a filter entry for an IPv6 source address and prefix length
to the current standard IPv6 access-list. If a sequence number is specified, the new
entry is inserted at the specified location. Otherwise, the new entry is added at the
end of the access-list.
The no variant of this command removes a filter entry for an IPv6 source address
and prefix from the current standard IPv6 access-list. You can specify the filter
entry for removal by entering either its sequence number, or its filter entry profile.
Syntax [icmp]
[<sequence-number>] {deny|permit}
{<ipv6-source-address/prefix-length>|any}
no {deny|permit} {<ipv6-source-address/prefix-length>|any}
no <sequence-number>
Mode IPv6 Standard ACL Configuration
Default Any traffic controlled by a software ACL that does not explicitly match a filter is
denied.
Usage The filter entry will match on any IPv6 packet that has the specified IPv6 source
address and prefix length. The parameter any may be specified if an address does
not matter.
NOTE: Software ACLs will deny access unless explicitly permitted by an ACL action.
Examples To add an ACL filter entry with sequence number 5 that will deny any IPv6 packets
to the standard IPv6 access-list named my-list, enter the commands:
awplus# configure terminal
awplus(config)# ipv6 access-list standard my-list
awplus(config-ipv6-std-acl)# 5 deny any
Parameter Description
<sequence-number> <1-65535>
The sequence number for the filter entry of the selected
access control list.
deny Specifies the packets to reject.
permit Specifies the packets to accept.
<ipv6-source-
address/prefix-
length>
IPv6 source address and prefix-length in the form X:X::X:X/P.
any Any IPv6 source host address.
To Next Page
Loading...
Need help?
General
