Allied Telesis IE340 Series - server enable

C613-50631-01 Rev A Command Reference for IE340 Series 2491
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
LOCAL RADIUS SERVER COMMANDS
SERVER
ENABLE
server enable
Overview This command enables the local RADIUS server. The local RADIUS server feature is
started immediately when this command is issued.
The no variant of this command disables local RADIUS server. When this command
is issued, the local RADIUS server stops operating.
Syntax
server enable
no server enable
Default The local RADIUS server is disabled by default and must be enabled for use with
this command.
Mode RADIUS Server Configuration
Examples To enable the local RADIUS server, use the following commands:
awplus# configure terminal
awplus(config)# radius-server local
awplus(config-radsrv)# server enable
To disable the local RADIUS server, use the command:
awplus# configure terminal
awplus(config)# radius-server local
awplus(config-radsrv)# no server enable
Related
commands
server auth-port
show radius local-server statistics