C613-50631-01 Rev A Command Reference for IE340 Series 530
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
ALARM MONITORING COMMANDS
ALARM
FACILITY EPSR LED
alarm facility epsr led
Overview Use this command to make the fault LED flash if EPSR detects that a link has gone
down.
Use the no variant of this command to remove this alarm.
Syntax
alarm facility epsr led
no alarm facility epsr led
Default By default, there are no alarms
Mode Global Configuration
Usage notes You can also use a relay to trigger an external alarm output, such as a buzzer, by
using the command alarm facility epsr relay.
Example To flash the LED if EPSR detects that a link has gone down, use the commands:
awplus# configure terminal
awplus(config)# alarm facility epsr led
To remove that alarm, use the commands:
awplus# configure terminal
awplus(config)# no alarm facility epsr led
Related
commands
alarm facility epsr relay
show alarm facility settings
show alarm facility status
Command
changes
Version 5.4.9-1.1: output-member parameter added on IE510-28GSX switches
To Next Page
Loading...
Need help?
General
