C613-50631-01 Rev A Command Reference for IE340 Series 645
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
VLAN COMMANDS
PRIVATE
-VLAN UFO TRAP
private-vlan ufo trap
Overview Use this command to enable the sending of SNMP traps for private VLAN UFO.
Use the no variant of this command to disable the sending of SNMP traps for
private VLAN UFO.
Syntax
private-vlan ufo trap
no private-vlan ufo trap
Default Enabled.
Mode Global Configuration
Usage notes This command enables SNMP traps for private-vlan UFO. If enabled, traps will be
sent when any UFO VLAN becomes "isolated", which occurs when traffic can not be
forwarded at Layer 2 because there is no upstream port for the UFO VLAN, and
Layer3 forwarding has not been configured for the VLAN.
Example To configure a private-vlan UFO trap use the commands:
awplus# configure terminal
awplus(config)# private-vlan ufo trap
Related
commands
private-vlan
snmp-server enable trap
Command
changes
Version 5.4.7-2.1: command added
Version 5.4.8-2.1: added to SBx8100 Series products
Version 5.4.9-0.1: added to x530 Series products
Parameter Description
ufo Specifies private-vlan for those VLANs in UFO mode.
trap Enables or disables SNMP trap sending for private-vlan UFO.
To Next Page
Loading...
Need help?
General
