C613-50631-01 Rev A Command Reference for IE340 Series 2146
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
QOS COMMANDS
REMARK
NEW-COS
remark new-cos
Overview This command enables you to configure and remark either or both of:
• the CoS flag in the data packet
• the input into the CoS to queue map, thus changing the destination egress
queue.
Syntax
remark new-cos <0-7> [internal|external|both]
no remark new-cos [internal|external|both]
Mode Policy Map Class Configuration
Usage notes The default CoS to Queue mappings are shown in the following table:
The relationship between this command and the CoS to queue map is shown in
the following figure.
Parameter Description
<0-7> The new value for the CoS flag and/or the input into the CoS to queue
map.
external Remarks the CoS flag in the packet.
internal Remarks the new-CoS input into the CoS to queue map.
both Remarks (with the same value) both the CoS flag in the packet and the
input to the CoS to queue map.
CoS Value 0 1 2 3 4 5 6 7
Egress Queue No 2 0 1 3 4 5 6 7
To Next Page
Loading...
