Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 780
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
UNIDIRECTIONAL LINK DETECTION (UDLD) COMMANDS
UDLD
RESET
udld reset
Overview Use this command to reset the status of any interface disabled by UDLD.
Syntax
udld reset
Mode Global Configuration
Example To reset an interface that has been disabled by UDLD, use the commands:
awplus# configure terminal
awplus(config)# udld reset
Output Figure 18-7: Example output from udld reset, when 2 ports are disabled
Figure 18-8: Example output from udld reset, when no ports are disabled
Related
commands
show udld
udld enable
awplus#udld reset
2 ports disabled by udld reset
awplus#udld reset
No ports are disabled by udld reset

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English