C613-50631-01 Rev A Command Reference for IE340 Series 2001
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
IPV4 HARDWARE ACCESS CONTROL LIST (ACL) COMMANDS
SHOW
INTERFACE ACCESS-GROUP
show interface access-group
Overview Use this command to display the access groups attached to a port. If an access
group is specified, then the output only includes the ports that the specified access
group is attached to. If no access group is specified then this command displays all
access groups that are attached to the ports that are specified with <port-list>.
Note that access group is the term given for an access-list when it is applied to an
interface.
Syntax
show interface <port-list> access-group
[<3000-3699>|<4000-4699>]
Mode User Exec and Privileged Exec
Example To show all access-lists attached to port1.0.1, use the command:
awplus# show interface port1.0.1 access-group
Output Figure 38-5: Example output from the show interface access-group command
Related
commands
access-group
Parameter Description
<port-list> Specify the ports to display information. A port-list can be
either:
• a switch port (e.g. port1.0.6) a static channel group (e.g.
sa2) or a dynamic (LACP) channel group (e.g. po2)
• a continuous range of ports separated by a hyphen, e.g.
port1.0.1-1.0.6 or port1.0.1-port1.0.6 or po1-po2
• a comma-separated list of ports and port ranges, e.g.
port1.0.1,port1.0.3-1.0.6. Do not mix switch ports, static
channel groups, and LACP channel groups in the same
list.
access group Select the access group whose details you want to show.
<3000-3699> Specifies the Hardware IP access-list.
<4000-4699> Specifies the Hardware MAC access-list.
Interface port1.0.1ď€
access-group 3000ď€
access-group 3002ď€
access-group 3001
To Next Page
Loading...
Need help?
General
