C613-50631-01 Rev A Command Reference for IE340 Series 2919
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
LOCATE
(AMF-PROVISION)
locate (amf-provision)
Overview This command changes the present working directory to the directory of a
provisioned node. This makes it easier to edit files and create a unique provisioned
node in the backup.
This command can only be run on AMF master nodes.
NOTE: We advise that after running this command, you return to a known working
directory, typically flash.
Syntax
locate
Mode AMF Provisioning
Example To change the working directory that happens to be on device1 to the directory of
provisioned node device2, use the following command:
device1# atmf provision node device2
device1[atmf-provision]# locate
The directory of the node device2 should now be the working directory. You can
use the command pwd to check this, as shown in the following figure.
Figure 57-9: Sample output from the pwd command
The output above shows that the working directory is now the flash of device2.
Related
commands
atmf provision (interface)
atmf provision node
clone (amf-provision)
configure boot config (amf-provision)
configure boot system (amf-provision)
copy (amf-provision)
create (amf-provision)
delete (amf-provision)
identity (amf-provision)
license-cert (amf-provision)
locate (amf-provision)
pwd
show atmf provision nodes
device2#pwdď€
card:/atmf/building_2/nodes/device2/flashď€
To Next Page
Loading...
Need help?
General
