Allied Telesis IE340 Series - Page 2918

C613-50631-01 Rev A Command Reference for IE340 Series 2918
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
LICENSE
-CERT (AMF-PROVISION)
To confirm that the license certificate has been applied to the provisioned node,
use the command show atmf provision nodes. The output from this command is
shown below, and displays license certification details in the last line.
Figure 57-8: Sample output from the show atmf provision nodes command
Related
commands
atmf provision (interface)
atmf provision node
clone (amf-provision)
configure boot config (amf-provision)
configure boot system (amf-provision)
create (amf-provision)
delete (amf-provision)
identity (amf-provision)
locate (amf-provision)
show atmf provision nodes
Command
changes
Version 5.4.9-0.1: syntax change due to new AMF provisioning mode
device1#show atmf provision nodes 

ATMF Provisioned Node Information: 

Backup Media .............: SD (Total 3827.0MB, Free 3481.1MB)

Node Name : device2
Date & Time : 06-Oct-2016 & 23:25:44
Provision Path : card:/atmf/nodes

Boot configuration :
Current boot image : x510-5.4.6-1.4.rel (file exists)
Backup boot image : x510-5.4.6-1.3.rel (file exists)
Default boot config : flash:/default.cfg (file exists)
Current boot config : flash:/abc.cfg (file exists)
Backup boot config : flash:/xyz.cfg (file exists)

Software Licenses :
Repository file : ./.configs/.sw_v2.lic
: ./.configs/.swfeature.lic
Certificate file : card:/atmf/lok/nodes/awplus1/flash/.atmf-lic-cert